Adventures in 3D Printing Terrain

Moderators: Vis Bellica, Laffe

Post Reply
User avatar
john de terre neuve
Posts: 2118
Joined: Tue Sep 03, 2013 11:37 pm
Location: Massachusetts
Contact:

Adventures in 3D Printing Terrain

Post by john de terre neuve »

Image

I recently bought a 3D Printer, mostly for terrain building. I wish I had the patience and skill of John Bond and MLB, the quaility of their work is just amazing. But for me the printer has been a good substitute.

I detail my initial experience and prints https://fuentesdeonoro.blogspot.com/sea ... %20Terrain. I have had a lot of fun with it.

John
User avatar
DougM
Posts: 661
Joined: Wed Oct 08, 2014 7:22 am

Re: Adventures in 3D Printing Terrain

Post by DougM »

Looks good John. The buildings have come out very nicely indeed, and the painting really sets off the models.

One observation I will make, is that plants on tiles usually grow fairly haphazardly or down a water leak line.
---------------------------------------------
https://aleadodyssey.blogspot.com/
---------------------------------------------
User avatar
hendrik
Posts: 136
Joined: Sun Aug 05, 2018 9:32 pm

Re: Adventures in 3D Printing Terrain

Post by hendrik »

looking ace john! it's a whole different hobby, 3D printing terrain, but I personally love it!
A good trick to avoid seeing those print lines is to coat the model with some vallejo white stucco, either flat, (by wetting it a bit, or by applying a stippling effect.
It really helps if you like washes in your buildings
User avatar
redmist1122
Posts: 740
Joined: Sat Mar 21, 2015 1:58 am
Location: Arizona, USA

Re: Adventures in 3D Printing Terrain

Post by redmist1122 »

Very nice! What size or kind of printer do you have?
Greg P.
Tucson, AZ, USA
User avatar
john de terre neuve
Posts: 2118
Joined: Tue Sep 03, 2013 11:37 pm
Location: Massachusetts
Contact:

Re: Adventures in 3D Printing Terrain

Post by john de terre neuve »

Thanks for the advice, I am learning. I tried stucco on a couple of building but am now going with PVA and fine sand as it is a lot easier. As I go forward and in less of a rush I will start printing at a higher resolution. I will look at the Vallejo product.

I do find placing the green on the buildings a bit of a challenge, this will improve as I go on. The 1st couple of attempts where way to thick and delineated.

Greg, it is a Creality 10S, just under $400 on Amazon in the US. It works well with a 300x300mm build plate with a height of 400mm.

John
Post Reply